Posted by WH on November 23, 1998 at 19:51:13:

Howdy, all,

I traced my disappearing clutch fluid problem to a leaky slave cylinder (surprise). The next
question is to take the cylinder out so I can either replace or repair it. I took a quick look
at it tonight, and it appeared that I'll have to remove most of the floor board and possibily the
lower bulk head to get to the slave cylinder. Is there an easier way to do this? Or do I have
to just keep buying the brake fluid by the gallon....

Wayne

Follow Up Messages

• Re: Replacing slave cylinder... Not so bad MG/WCB 01:24:10 11/27/98 (0)
• It's hard Ben 01:02:05 11/24/98 (0)
• It's hard Ben 00:57:55 11/24/98 (2)
  • Re: It's hard WH 15:08:46 11/24/98 (1)
    • Re: Re: It's hard ben 01:35:30 11/25/98 (0)