Posted by dgj95lwb on April 11, 2002 at 20:21:45:

In Reply to: Re: Re: Brake Master Cylinder or Servo posted by sean on April 11, 2002 at 09:55:36:

Install tip: (I too concur that you need a m/c)
To get it ready to fit, buy enough brake fluid that you can submerge the new unit, then pump/press the piston in and release several times all the while it is submerged. This will preload/recharge and expell air from a new m/c. Makes it much easier to bleed the system. Use DOT4 fluid, you will need 3 qts, Castrol preferred.

Bleed the system as per the manual. Cheers- doug