Re: Fairey Overdrive Again
Posted by MG/WCB on September 06, 1998 at 22:46:53:
In Reply to: Fairey Overdrive Again posted by Ana S on September 06, 1998 at 22:16:44:
Doesn't matter which LR... still need special tool for mainshaft nut.
OD goes in PTO hole, thus cover must be removed, locktoab bent back & nut removed, then gear can be removed. OD bearing/gear must be fitted on mainshaft, l/tab & nut... torque to 100 ft lbs, bend over l/tab... all 3 tabs MUST be bent over otherwise they will foul OD gear inside OD. Fit new gasket. Slide OD into place, may not go all the way in, thus you'll have to turn engine over with key (transfer in "N", mainbox in 1st, DO NOT START ENGINE!)... when you punch starter push on OD and it'll go in. Now you'll have to slowly pull it back out (but gears will now be lined up) so you can fit nuts (3/8" BSF wrench). Tighten all nuts. Without instruction sheet or knowlegde of fabrication, fitting the lever will be near impossible (even I need the instruction sheet to speed process of measuring/etc to bore hole for lever). May have a copy @ shop. 925-606-8301. MG
Follow Up Messages
|
